The IsoCap I-ST-1c is a sensor designed for high-quality isolated current measurements up to 100A mperes. The IsoCap I-ST-1c module provides 1500VAC primary-to-secondary sustained isolation, which allows users to monitor a miscellaneous of currents at different potentials.
Input ranges | ±10mA, ±20mA, ±30mA, ±50mA, ±100mA, ±200mA, ±300mA, ±500mA, ±1A, ±2A, ±3A, ±4A, ±5A, ±10A, ±20A, ±30A, ±50A, ±60A, ±70A, ±80A, ±100A, 100A AC,custom |
Input-Output non-linearity | <280ppm/A |
Gain temperature drift | ±50ppm/°C |
Isolation voltage from primary to secondary | >±2000V |
Power Supply Voltage | 12Vto28V |
Output type | Differential signal |
Output Offset Voltage | 2σ<±500μV (typical) 4σ<±1mV (limit) |
Output impedance | 100Ω |
Common mode impedance | >2GΩ || 4pF |
Max Input delay | <5μs |
Operating temperature | – 25 to 65°C |
Storage temperature | – 40 to 70°C |
Mounting Type | DIN Rail |
Weight | 86g (7.2oz) |
The IsoCap I-ST-1c is a sensor designed for high-quality isolated current measurements up to 100 Amperes. The IsoCap I-ST-1c module provides 1500VAC primary-to-secondary sustained isolation, which allows users to monitor a miscellaneous of currents at different potentials. IsoCap I-ST-1c uses shunt methodology to measure the current flowing through the input conductor. In essence, this technique works by placing a high performance low impedance resistor along the current path (primary), while a galvanic isolation separates primary and secondary sides.
The compact form factor of the IsoCap I-ST-1c module allows users to setup high channel density monitoring systems, making it ideal for deployed and portable systems.
Accuracy (percentage of reading) | ±( 0.2% of reading + 0.005% range) ±( 0.1% of reading + 0.005% range |
Max total phase shift at 50Hz | <0.05° |
Max Input delay | <5μs |
Isolation voltage from primary to secondary | >±2000V |
Withstanding common mode surge voltage (1min) | ±5000V |
Thermal drift gain | <±0.01%/°C |
The current input connector is located at the top of the module in the figure bellow. A connector that servers to power the unit , output signal and ground the sensor lay along the bottom.