The IsoCap V2I module has been designed to provide low-cost and high-quality translation of voltage measurements into current loop signal.
Max Input delay:< 2.8μs Bandwidth:500kHz Output current:4 - 2mAThe IsoCap V2I module has been designed to provide low-cost and high- quality translation of voltage measurements into current loop signal.
The IsoCap V2I is a compact two-wire transmitter that converts a process level DC voltage input to a proportional 4-20mA control signal. Power is received a local DC supply when using a two wire connection.
Input-Output non-linearity | < 70 ppm |
Output current | 4 - 2 mA |
Gain temperature drift | ± 50 ppm/°C |
Common mode rejection at 60Hz | 105 dB |
Bandwidth | 500 kHz |
Power Supply Voltage | 12 V - 36 V |
Output type | Current loop |
Differential Input impedance | > 8 MΩ |
Common mode impedance | > 2 GΩ || 4 pF |
Maximum Output Load | 500 Ω |
Accuracy (percentage of reading) | ± 0.2 % |
Max total phase shift at 50Hz | < 0.05 ° |
Max Input delay | < 2.8 μs |
Integrated sensor noise (Referenced to input) | < 50 μA |
Total power consumption | 1.5 W |
Input Dynamic Range | ± 5 V, ± 10 V, custom |
The voltage input connector is located at the top of the module in the figure bellow. A connector that servers to power the unit, ground and output the sensor signal lay along the bottom.
The V2I module is designed to mount on standard NS-35 or NS32 DINrails with minimal preparation, providing users ease of use and flexibility.
Signals are connected into the V2I via the Spring Cage connector and routed as the wiring diagram above.